- MAS BT30 Retention knobs for BT30 Tool Holders
- Works on all BT 30 machines
- For MAS BT30 Spindles
- Threaded is M12 X1.5
- All critical surfaces precision ground
- Made from alloy steel hardened to 54 – 56rc
- Thru twice heat treatment of each pull stud
- Angle degree have 45,60 and 90 available
- Concentricity is less than .0005 at collet face
- Coolant available
- Rear thread for pull stud is M12x1.5
- Oxide black
MAS BT30 45° 60° 90° Retention knob Pull Stud For Tool Holders
MAS BT30 45° Retention knob Pull Stud For Tool Holder
High-quality low-carbon alloy steel is used for thread processing after quenching.
This type of stud shank has high hardness, wear-resistance, and long service life.
The hardness from the surface of the nail to the core gradually decreases, and the impact resistance is strong.
The size standard is suitable for high-end tool holders; the appearance is all black,
with high internal quality and Good rust effect, widely used abroad, a key recommendation
Pull stud working principle
The working system of the tool holder pull stud: one end of the pull stud is connected to the machine tool bayonet and one end is connected to the tool holder, and the d part is snapped in according to the degree of the machine tool bayonet, and the thread and the tool holder are tightened.
The axial force transmitted through the pull rod and Tie rod joints and pull studs to tighten the handle. When changing the tool, it is required to loosen the tool holder. When the pull stud is installed on the main shaft of the ordinary machine tool or CNC machine tool, the circular arc joint of the rod body is connected to the front end of the pull rod structure, and the screw joint of the pull stud is extended into the spindle shaft hole.
The internal screw holes of the tool holder are matched and connected to realize the use of the tool holder on ordinary machine tools and CNC machine tools so that the tool holder can be used in both machining centers and ordinary machine tools and CNC machine tools, which improves the tool holder. Versatility reduces production costs.
We accept Custom OEM Order
MAS BT30 Retention knob Pull Stud For Tool Holder 403-1982
|BT30||Product NO.||BT30 45 60 90 degrees available|
|Insulation material||Hardened Alloy Steel|
|Standard Spindle||BT30 Taper|
Drawings & downloads
All BT Retention Knobs Pull Stud available
We do have 11 steps to checking retention knob to keep each pull stud in high-performance products on your tool holder
From material -production online -Longlife time testing -resistance testing and run out testing