BT40 Face Mill Tool Holder Shell Mill Arbor

Home|CNC MACHINE TOOLS|Tool Holders|BT40 Tool Holders|BT40 Face Mill Tool Holder Shell Mill Arbor

BT40 Face Mill Tool Holder Shell Mill Arbor

  • BT40 Face Mill Tool Holder
  • Works on all  BT40 machines
  • From 16mm to 50mm
  • All critical surfaces precision ground
  • Made from alloy steel hardened to 54 – 56rc
  • Balanced to G2.5 at 25,000 RPMs
  • Gage length is ( from 0.5″ to 8 inches)
  • Concentricity is less than .0001 at collet face
  • Screw include
  • Rear thread for pull stud is M16x2
  • Color: oxide black
Category:

Description

BT40  Face Mill Tool Holder Shell Mill  Arbor

The IGSTOOL Tool holder is balanced to G2.5 25,000 RPM on Germany HAIMER Tool Dynamic Balancing System,
Each Tool Holder with QC report card. 100% guarantee of each tool holders  in the high-performance
Balanced tool holder minimizes the centrifugal forces which minimize the stress on spindle bearing,
minimize vibration and maximize the cutting tool’s life a long time  and greatly improve surface finish

 

We accept Custom OEM Order 

Specification

  Face Mill Tool Holder

BT40 Size available   3/4 to 2″ or 16mm to 50mm
Insulation material Hardened Alloy Steel
Hardness HRC 55
Run Out (TIR) <0.0002″ or 0.005mm
Color Oxide Black
 Standard Spindle  BT40 Taper
Stop Screw yes
Manufacture IGSTOOL

BT40 Taper Application Guide

 

BT40 Face Mill Tool Holder

 

 

BT Face Mill Tool Holder series for face milling cutter. The whole through-hole is good for the water outlet and has good shock resistance. Material: Titanium alloy 20CrMnTi is used, which has good elasticity and wear resistance after heat treatment, high precision, wear-resistance, and durability. The tool holder has a hardness of 52-55 degrees, low noise, small wind resistance, and high accuracy of repeated clamping. Mainly used for tool holder and tool holding in drilling, milling, reaming, tapping and grinding