BT40 Testing Bar Gage Tool TIR 0.0002μm Gage length 12″

Home » Products » BT40 Testing Bar Gage Tool TIR 0.0002μm Gage length 12″

BT40 Testing Bar Gage Tool TIR 0.0002μm Gage length 12″

  • BT40 Testing Bar Gage Tool TIR 2μm Gage length 12″
  • Works on all CAT 40 machines
  • Gage length: 12 inches
  • Gage diameter: 2 inches
  • All critical surfaces precision ground
  • Made from alloy steel hardened to 54 – 56rc
  • Balanced to G2.5 at 15,000 RPMs
  • Rear thread for pull stud is M16x2
  • Color: Silver
Category:

Description

BT40 Testing Bar Gage Tool TIR 0.0002μm Gage length 12″

The IGSTOOL Face Mill Tool holder is balanced to G2.5 15,000 RPM on Germany HAIMER Tool Dynamic Balancing System,
Each Tool Holder with QC report card. 100% guarantee of each tool holders  in the high-performance
Balanced tool holder minimizes the centrifugal forces which minimize the stress on spindle bearing,
minimize vibration and maximize the cutting tool’s life cycle and greatly improve surface finish

 

We accept Custom OEM Order 

Specification

     BT40 Tool Probe Calibrator Calibration Gage Tool

BT40 Working Spindle  BT40
Insulation material Hardened Alloy Steel
Gage Length 12 inches  Tolerance +- 0.0003  or 0.01mm
Probe diameter 2″  +- 0.0002 or 0.005mm
Color Silver
 Standard Spindle  BT40 Taper
Run out 0.0001 or 0.003mm
Manufacturer Part No IGST0107

 

 

                                                                              Application Guide CAT Spidle Size

 

                    BT40 Testing Bar Gage Tool TIR 0.0002μm Gage length 12″

 

                             it can be kept in tool changer for periodic probe calibration and can be used to calibrate your table tool probe